0.875THF Floor Mount Adapter
Install permanent monuments in the floor
The 0.875THF is meant to be grouted or epoxied permanently into holes which have been drilled in concrete floors or walls, so that the top is flush with the surface of the floor or wall. An aggressive knurl around the circumference as well as large concave grooves give this target mount lots of holding power in the surrounding grout. The cap has an O-ring seal to keep the target mount surfaces out of danger and free of debris. The 0.875THF may be attached to a customer-provided positioning jig while being grouting in place, via the M4 threaded hole on top of the lid. In this way, the 0.875THF can be easily positioned so that the top is flush with the floor or wall, and in the desired position. A flat or straight screw driver allows easy removal of the lid.
The 0.875″ SMR seats on a 3-point conical land and is held firmly in place by a ring magnet.
May Be Used With
Any 0.875″ diameter SMR
1.25″ (31.75mm) diameter x 1.5″ (38.1mm) high
Material: Stainless steel
Hardness: HRC 42-45