|
|
|
The 1.5ADP-.5 magnetic adapter gives you the ability to
simulate a 1.5" SMR while actually using a 0.5" SMR. The adapter
is a partial 1.5" diameter ball, precisely machined to hold
the center of a 0.5" SMR at exactly the same point in space
as a 1.5" SMR. This allows you to accurately
measure the locations of nests and target mounts designed for 1.5" SMRs.
It also allows you to use measurement routines and macros
designed for use with a 1.5" SMR.
The 1.5ADP-.5 comes in handy if you are switching SMR sizes during
one measurement
session in order to accommodate various nest sizes on your
fixture or tools. Use it to avoid performing an extra
home-point calibration on laser trackers when you're already
set up to use a 1.5" SMR. It's also great for use with
built-in
 reference systems designed for 1.5" SMRs - it gives
you the 0.750" offset that you need, and allows you more
freedom to switch back and forth between 1.5" and .5" SMR
targets. It also gives you more flexibility when using a calibration ball
bar which only has adapters
for 1.5" SMRs.
The centerpoint of a 0.5" diameter SMR is held precisely
0.75" or 19.05mm above the surface of the part being measured. The
SMR seats on a conical land and is held in place by a magnet.
|
|
Tolerance: 0.5" SMR held to center
of 1.5" diameter ball within ±0.00025" (0.006mm) |
Material: 440-C Stainless steel
Hardness: HRC 56-61 |
- Holds any 0.5" diameter SMR
- Fits in any 1.5" SMR nest
|
|
